Front axle couplings redBTR for UAZ vehicles are designed to disconnect / connect the front wheels of the car to the transmission and front axle drives. Contribute to the reduction of fuel consumption, increase the service life of the front axle transmission. Effective use in urban environments, as well as over long distances and travel. In off-road conditions, wheel hubs for UAZ are guaranteed to withstand high loads transmitted from the axle shaft to the hubs.
Designed for use on vehicles of UAZ LLC of all models and PJSC GAZ 69. Applicable for vehicles with wheels - up to 35 inches.
Black clutch housingredBTR UAZ Z series made by cold stamping, without preheating of the workpiece. For metals and alloys, such pressure treatment corresponds to the conditions of cold plastic deformation, accompanied by a change in physical and mechanical properties. This allowed redBTR to produce a wheel coupling for UAZ vehicles with the best performance (increased strength, high hardness and wear resistance) with a relatively low part weight.
The new housing production technology has made it possible to maximize the reliability of the connections, and the high level of dust and moisture protection (IP67), thanks to the introduction of a sealing silicone gasket, makes it possible to use new couplings for connecting the drive redBTR in virtually all operating conditions.
The number of half shaft splines - 10 pcs. Number of fixing bolts - 6 pcs. The diameter of the location of the mounting holes is 89.80 mm.
Attention! UAZ LLC, GAZ PJSC is not a manufacturer of this product "Front axle couplings (wheel hubs) redBTR (Z series)". Trademarks "UAZ" and "GAZ" are used solely for informational purposes to show the buyer the applicability of this product, in accordance with the requirements of the current legislation of the Russian Federation.