Clutches for connecting the front axle redBTR UAZ are designed to disconnect / connect the front wheels of the car to the transmission and front axle drives. Contribute to the reduction of fuel consumption, increase the service life of the front axle transmission. This is especially true when operating a car in urban areas, as well as over long distances. In off-road conditions, wheel hubs are guaranteed to withstand the loads transmitted from the axle shaft to the hubs.
Designed for use on UAZ LLC vehicles of all models and PJSC GAZ 69. Applicable for vehicles with wheels up to 35 inches.
Coupling body redBTR UAZ Z series made by cold stamping, without preliminary workpiece heating. For metals and alloys, such pressure treatment corresponds to the conditions of cold plastic deformation, accompanied by a change in physical and mechanical properties. This allowed redBTR to produce a wheel coupling with the best performance (increased strength, high hardness and wear resistance) at a relatively low part weight.
The new housing production technology has made it possible to maximize the reliability of the connections, and the high level of dust and moisture protection (IP67), thanks to the introduction of a sealing silicone gasket, makes it possible to use new couplings for connecting the drive redBTR in virtually all operating conditions.
The number of half shaft splines - 10 pcs. Number of fixing bolts - 6 pcs. Bore hole diameter - 89.80 mm.
Attention! UAZ LLC, GAZ PJSC is not a manufacturer of this product "Front axle couplings (wheel hubs) redBTR (Z series)". Trademarks "UAZ" and "GAZ" are used solely for informational purposes to show the buyer the applicability of this product, in accordance with the requirements of the current legislation of the Russian Federation.